#Mac os 9.1 windows emulator for mac os#
#Mac os 9.1 windows emulator mac os x#
#Mac os 9.1 windows emulator install#
#Mac os 9.1 windows emulator driver#

Right out of the box, it will network through your host machine but on its own subnet branch.

#Mac os 9.1 windows emulator driver#

Networking is fully functional thanks to the sungem driver that's already pre-configured in these downloads. BTW, if you need a larger disk image, you can grab one instantly from here: Blank hard drive disk images (3GB HFS up to 30GB HFS+)

#Mac os 9.1 windows emulator mac os x#

The Mac OS X package contains Mac OS X 10.4.11. The Mac OS 9 package contains a 1GB disk image on which Mac OS 9.2.2 is already fully installed. Nevermind the yellow screen with a VRAM partition not found error, it will go past this without any problem.

#Mac os 9.1 windows emulator for mac os#

Just launch the 'QEMU - Mac OS 9.2.2.bat' (or 'QEMU - Mac OS X Tiger 10.4.11.bat') file and wait 30 seconds for Mac OS to boot up. These bundles were put together by 'that-ben' and are intended to be the easiest possible for beginners.

QEMU can run on almost all imaginable CPU architectures, even ARM (e.g.: Raspberry Pi).

Cursor animation (or anything else for the matter) does not reset the pointer in the host OS (SheepShaver does and it's annoying!).

Much more stable networking (SheepShaver randomly crashes while using the networking features).

Mac OS 9.1.x and 9.2.x emulation (SheepShaver cannot).

At some point in the near future hopefully, QEMU will fully replace SheepShaver, but at the moment, SheepShaver still runs faster in most situations. Note that QEMU can also emulate Mac OS X 10.0 up to 10.5. In 2016, QEMU could finally achieve what has never been possible before: emulating Mac OS 9.0.4, 9.1 and 9.2.2 (albeit still it's quite slow and the sound support is kind of buggy at the moment). QEMU is a very versatile and extremely broadly supported open source virtual machine emulator. On OS X Tiger, I also have a lot of console emulators installed.What is QEMU for Windows - PPC emulator, runs Mac OS 9.1, 9.2 + OSX 10.0 to 10.5? SoftPC, Virtual PC v3, SoftWindows and a bunch of others.

So far, Mini vMac and Fellow (Amiga emu), No$GB (Gameboy), QB8086 (PC emu), MZemu (MZ-700/800 emu), VGB (Gameboy).Д®dit: Ironically I'm often running DOS on Macs (PPC). I'm also doing all my experiments on (a special) DOS mainly. Marathon - Runs fine, mouse also works better This is an old emulator from around 2000, and it also runs in pure DOS. Since DOS is a single task OS, it feels much more like I'm using a 'real' Mac OS So far this is my favorite 68K mac emulator simply because I can run it under pure DOS. Marathon - Runs fine, mouse also works better still sucks Warcraft - Runs full speed, but CD audio is not working Blackthorne - Does not work, same error 14 I get from Basilisk II Prince of Persia 2- Runs full speed and almost with functional music (it's a bit slow at some points, but still a little better than on Basilisk II)

#Mac os 9.1 windows emulator install#

I used Dosbox to install the OS and copy the games, then copied the image to my retro machine. Tried running on an retro computer with MS-DOS, it's the easiest one to setup since you don't need any Mac OS installation and ROM. The other games didn't work.Blackthorne hangs up while loading and the other games crash to DOS Prince of Persia 1 - Runs full speed and with sound It runs pretty well in general, but it was kind of a pain to set up.Д®xecutor (not exactly an emulator but I had to try it): Marathon - Runs surprisingly well, but mouse twitches a lot (may be the KVM switch I use) Warcraft - Couldn't try since I was too lazy to make CD-ROM work Prince of Persia 2 - Runs full speed, but music is slow Prince of Persia 1 - Runs full speed with music and sound I tried some emulators myself, here are the results: